![]() etc/X11//nf Section "OutputClass"Ī reboot may be required for the setting to be effective. For Xorg use the "modesetting" driver with AccelMethod "none" and MatchDriver "evdi".Ĭreate a file with the following content:.For Xorg it allows configuring DisplayLink monitors using xrandr in the same manner as the udl driver for Wayland no configuration is necessary. If you encounter issues, there are some upstream patches applied to evdi-compat-git AUR as an alternative. Install evdi-git AUR ( evdi AUR is currently obsolete) for the in development kernel module. ![]() USB 3.0 DL-6xxx, DL-5xxx, DL-41xx, DL-3xxx Devices If you are using an earlier version of that package or have CONFIG_FB_UDL=m set in your kernel config, you need to blacklist the old kernel module, udlfb, which may attempt to load itself first. This should work without any configuration changes on linux 4.14.9-1 and later. It allows configuring DisplayLink monitors using xrandr. The kernel DRM driver for DisplayLink is udl, a rewrite of the original udlfb driver. ![]() Installation USB 2.0 DL-1x5, DL-1x0 Devices ![]() a DisplayPort monitor, especially when large portions of the screen are being redrawn. The steps on this page describe the generally most successful methods of using external monitors with DisplayLink.Īlso be warned that even over USB 3.0, a DisplayLink monitor may exhibit noticeably more lag than e.g. While some people have had success in using them, it is generally not an easy process and not guaranteed to work. DisplayLink devices on Linux still only have experimental support.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |